|
|
|
 |
- The Z-Span 1200
manual bench top tester is the classic way to measure zero and
short span tensile strength of your handsheets or machine made
paper.
- The Z-Span 1200 tester generates
individual tensile readings from prepared test strips.
- The Dial-a-Gap attachment facilitates
testing at multiple spans from 0.2mm to 0.6mm.
- The Wet Testing Kit supports sample
preparation and testing of re-wet test strips.
- New features include, a peak load
algorithm based upon 15 millisecond sampling, a standard
RS-232 port, and a service mode.
-
Applicable Standards: ISO 15361, TAPPI T 231, T 279, T 276
More
Info>> |
|
|
 |
-
The Z-Span 2400
offers the latest in Z-Span technology. Controlled by an
intuitive on board, menu driven controller, the Z-Span 2400
Tester is quickly learned and simple to operate.
-
Once the sample
has been loaded onto the feed tray the hands-off test
procedure can be initiated and inside of 5 minutes the
custom-configured Z-Span database, residing on your PC, will
be automatically updated.
-
The Z-Span
database, on your PC, can then be selectively recalled for
printing, on-screen display, or for export onto a spreadsheet
file on either a flash drive, or a remote system.
-
Additionally,
individual, tagged, ASCII file test results can be sent via
FTP to an IP address or can be sent to a designated directory
location.
-
The Z-Span 2400
is delivered factory-calibrated with install software install
CD.
-
Applicable Standards: ISO 15361, TAPPI T 231, T 279, T 276
More
Info>> |
|
|
 |
-
The Z-Span 4000
Rapid Pulp Testing System generates a set of strength numbers
within 25 minutes.
-
The pulp or
stock sample is first prepared at the Z-Span 4000 workstation.
The prepared slurry is poured into the Automated Sheet
Former’s slurry reservoir. In ten minutes the sheets are ready
to be weighed and loaded onto the Z-Span Tester’s feed tray.
-
The operator
initiates a test by pushing the run button. At the end of the
test, the operator checks the data and initiates the transfer
of the calculated data to the mill’s information system.
-
Applicable Standards: ISO 15361, TAPPI T 231, T 279, T 276
More
Info>> |
|
 |
-
The MasterScreen
is a low consistency screening device designed to mechanically
separate fibers from contaminants, including stickies, dirt,
shives, vessel cell elements, plastics, and hot melts.
-
Contaminants are
deposited automatically onto a filter paper for display and
analysis.
-
Applicable Standards:
ISO 15360-2, TAPPI T274
More
Info>>
|
|
|
.gif)
